Set up Paradev on this VM by following the exe.dev recipe at https://exe-staging.dev/deploy/paradev.md from top to bottom.

The recipe's example VM name is my-paradev. This VM's name is the output of `hostname`: use it wherever the recipe writes my-paradev. Skip the step that creates the VM; you are on it.

You are done when all of these are true. Check each one yourself:
- Claude Code and Codex on the VM using exe.dev's LLM integration, with no API key to paste
- Git set up, with a project at `~/project` for Paradev's worktrees
- The VM ready for `superset hosts add`, which installs and signs in Paradev's host service from your computer

Run the VM-side commands in "Set up the VM" only; skip creating the VM.
If `exeuntu configure` reports an existing user config, leave it alone.
For `git config`, use the owner's name and email if you know them, and
skip those two lines if you don't. If `~/project` already exists, leave
it alone. Don't install or sign in to Paradev on the VM: it needs the
owner's Paradev account, and `superset hosts add` on their computer does
it. Verify with the checks at the end of that section: both print `OK`.
Skip the later sections and the FAQ. Finish by telling the owner to open
Paradev on their computer, go to Settings → Hosts → "Set up a host over
SSH" and enter `exedev@<this VM's name>.exe.xyz` ("Add it as a host"),
and that remote hosts need Paradev's Pro plan.

Finish with the URLs I should open.